Spilling solar lightpot

-
Today we will make spilling solar light for our garden. As we all know in the evening we need light for our gardens and if we can make a beautiful light lamp with less effort then why not...
      Things we need for this are 
  • Solar powered led light according to your required length I would recommend 50 to 60 feet length led light 
  •  An old tea pot or you can also use watering pot according to your choice.
  • A shepherd's hook.

  • Craft wire.
  • A large size washer.
  • Hot glue.
  • Snips 
 First start with unwrapping string lights and the length should be around 30 inch but thats up to your choice how long do you want.Then bend it from the middle.It will appear like this after that 
After bending it will look like a 15 inch single string, repeat the same procedure for several times 
  After finishing the hole process we  will work on putting it together and for that we will cut a 20 to 25 inch of craft wire
          After cutting the wire wrap the connected ends properly using the wire.
                   After wrapping the ends together put the other end of the wire inside the pot and take it out from the opening of the pot.
After doing that to secure the lights we will wrap the craft wire around the washer as shown here 
Wrap it completely untill the light will fall in place after keeping every thing in place close the mouth of the pot with the hot glue and try it before you set it in place.
And here we go our spilling solar light lamp is ready...

Comments

Post a Comment

Popular posts from this blog

GLASS ETCHING

-
Image
ETCHED GLASS: E tched glass gives a nice frosted and edgy look to your glass and its super easy to create this edged look to your glass at home. It doesn't have to be a wine glass,you can etch anything glass... mason jars,beer mugs,trifle bowls,candles stand etc... MATERIAL REQUIRED: Armor Etch cream Glass according t your choice Vinyl Transfer Tape Cricut or other cutting machine Paint brush  let's start the  procedure... First of all cut out your design on vinyl.I use cricut for cutting  but you can use any other cutting machine or you can even use stickers. Apply transfer tape to your vinyl and then apply it to glass where you want it. With rounded surfaces, I usually make slits around the edge to make sure it lays down flatter. Press all around to make sure it is really stuck every where! Then you can take off the transfer tape. Then start applying the etch cream. Make sure you do this in a ventilated area,it's pretty smell
Read more

Honeycomb shelf

-
Image
HONEYCOMB SHELF         Hello friends here I will show you how to make this kind of honeycomb shelfs for your walls.        Things we need for this are... A miter saw  Pin boards(1"×4"×6') A staple gun & staples Wood glue Measuring tape & pencil Wood stain & rags Disposable gloves Drop cloths First set your saw to make a 30 degree angle cut.Flip the wood after each cut so that the angels are facing opposite direction. Decide the length according to your requirement.Measure the wood and mark where cuts will be made. After making the pieces assemble it properly and stick it with the glue and staple it before hanging.   And your honeycomb shelf is ready, make as many as you want and use it for decorative purpose also... Friends it can fit in for any thing like for shelf, decorating purpose or for your wordrop etc.And its very easy to make but friends be carefull while cutting the wood.
Read more